2014年7月30日星期三

ship loader bearing matching precision crossed roller bearing installation

In order to improve the matching precision crossed roller bearing installation, must use the measurement methods and tools do not make the bearing deformation, precision measurement of bearing inner and outer circle with the surface size of the actual project, the measurement can be related to the inner and outer diameters of all be measured, and make a comprehensive analysis of the measured data according ship loader bearing to this, precision, matching with the shaft and hole of shaft
The installation part size. The distribution of shaft and hole in the actual measurement of the corresponding size and geometry, temperature and measurement should be carried out in the bearing under the same. To guarantee the higher actual tie effect, the shaft and hole matched with a bearing surface, the roughness should be as small as possible.
In the above measurement, should be in the outer circle and cross roller bearing inner hole, and the corresponding surface of the shaft and the seat hole, on both sides near the assembly chamfer, respectively two groups of marker can indicate the maximum deviation direction, so angular contact bearing that in the actual assembly, so that the large deviation match two party aimed at the same azimuth, in this assembly, both of deviation to partially offset. Make two groups to purpose, is the deviation compensation can be considered, the rotating precision bearings on both ends of the respective even increased, and the bearing seat hole and both ends of the trunnion coaxiality error are partially eliminated. The mating surface to surface strengthening measures, such as sandblasting, precision plunger Thrust Ball Bearings diameter slightly larger plug a hole, are beneficial to improve matching precision. Large and outer bearing surplus volume, in order to convenient installation, there also will be the outer circle and the bearing seat hole is made with a small taper, the installation on two square taper fit, and cover with control outer advance amount, the amount of interference in the predetermined range, while the end cover end face friction resistance of the outer end face also contribute to the fixed ring, to prevent the occurrence of peristalsis. This installation method is particularly convenient for bearing the vertical installation.

没有评论:

发表评论